Altec TTP-343 Series Manuel d'utilisateur télécharger pdf (Page 35)

Bline Mode

Scan Mark

Intensity x

Ref. Level xxx

3. Open the printhead mechanism, put

the black-mark under the media

sensor. Press the button

to set the value into the printer.

Bline Mode

Scan Paper

Intensity x

Ref. Level xxx

4. Then, put the label without black-mark

under the media sensor. Press the

button to set the value into

the printer.

Note:

Normally, the value of “Ref. Level” for mark should be larger than paper

for over 128. If the media sensor fails to do so, you have to manually

change the Intensity by pressing and to reach the

above value.

Bline Mode

Complete

Intensity x

Ref. Level xxx

5. The bline sensor calibration is

complete. Press the

button the LCD screen will return to

the previous menu.

B-3 Pre-Printed

This function can set the paper length and gap size before auto-calibrate the

sensor sensitivity. It can to get the sensor sensitivity accurately.

When enter [Pre-Printed] option, you will see following message. Please

complete there steps：

Paper Len.

00812 dot

1. Press the button to move

the cursor from left digit to right digit,

and press the button to set

the value from “0” to “9” and the “dot/

mm/ inch”. Press the

button to set the paper length into the

printer.

Bline Size

0024 dot

2. Press the button to move

the cursor from left digit to right digit,

and press the button to set

the value from “0” to “9” and the “dot/

mm/ inch”. Press the

button to set the bline size into the

printer.

Bline Mode 3/4

Manual

Pre-Printed

Exit

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 68 69

Commentaires sur ces manuels

Pas de commentaire

Altec TTP-343 Series Manuel d'utilisateur Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de codes-barres Altec TTP-343 Series